roslinda rosli,mardina abdullah, nur choiro siregar, nurul shazana abdul hamid, sabirin abdullah, gan kok beng, lilia halim,noridawaty mat daud, siti aminah bahari, rosadah abd majid, badariah bais.  (2019).  exploring space science through the ukm-sid pi outreach program.  - proceeding of the 2019 6th international conference on space science and communication (iconspace).  253-256. 

nur mas ayu jamaludin, muhamad ramdzan buyong, badariah bais, muhammad khairulanwar abdul rahim, azrul azlan hamzah & burhanuddin yeop majlis.  (2018).  dielectrophoresis : characterization of triple-negative breast cancer using clausius-mossotti factor.  - 2018 ieee international conference on semiconductor electronics (icse).  . 

norliana yusof, badariah bais, burhanuddin yeop majlis & norhayati soin,.  (2018).  sensitivity and q-factor trade-off analysis of mems pressure sensor for bladder implants.  - 2018 ieee 8th international nanoelectronics conferences (inec).  . 

mardina abdullah, rosadah abd majid, badariah bais, nor syaidah bahri & mohd hezri mokhtar.  (2018).  space weather monitoring system competition for secondary school students in malaysia.  - international conference on space science and communication (iconspace2017).  . 

nurul azzyaty jayah, badariah bais & burhanuddin yeop majlis.  (2018).  effect of flow rate towards microfluidic hollow fibre extraction efficiency.  - 13th ieee international conference on semiconductor electronics 2018 (icse2018).  . 

nur hazliza ariffin, norhana arsad & b. bais.  (2016).  low cost mems gyroscope and accelerometer implementation without kalman filter for angle estimation.  - ieee international conference on advances in electrical, electronic and systems engineering (icaeese2016).  77-81. 

abdullah h., wan jalal w.n., zulfakar m.s., islam m.t., bais b., saari s., idris s..  (2016).  fabrication and characterization of tio2-doped znal2o4nanocrystals via sol-gel method for gps antenna.  - materials science forum.  331-344. 

nurul jannah mukhtar, norazreen abd aziz, badariah bais and burhanuddin yeop majlis.  (2016).  circuit modeling of surface acoustic wave (saw) resonator with circular geometry.  - proc. 2016 ieee international conference on semiconductor electronics (icse2016), 17-19 aug. 2016 kuala lumpur.  57-60. 

rahim r.a., abubakkar s.f.o., bais b., majlis b.y..  (2015).  analysis of electrical responses of mems piezoresistive microcantilever.  - proceedings - 5th international conference on computer and communication engineering: emerging technologies via comp-unication convergence, iccce 2014.  123-126. 

rosadah abd majid, mardina abdullah, badariah bais, alina marie hasbi, nor syaidah bahri, siti aminah bahari, mohd hezri mokhtar.  (2015).  malaysian students` perception and attitude towards space science: a pilot study.  - proceeding of the 2015 international conference on space science and communication (iconspace), 10-12 august 2015, langkawi, malaysia.  297-301. 

jumril yunas, muzalifah mohd said, burhanuddin yeop majlis and badariah bais.  (2014).  finite element analysis and preliminary fabrication of flexible membrane with embedded magnetic nanoparticles.  - advanced materials research.  147-150. 

norazreen abd aziz; badariah bais; muhamad ramdzan buyong; burhanuddin yeop majlis; anis nurashikin nordin.  (2014).  fem analysis of wavelength effects in piezoelectric substrate.  - 2014 ieee international conference on semiconductor electronics (icse 2014).  259-262. 

muzalifah mohd said, jumril yunas, roer eka pawinanto, burhanuddin yeop majlis, badariah bais.  (2014).  synthesization of nickel nanoparticles embedded in su8 polymer for electromagnetic actuator membrane.  - ieee international conference on semiconductor electronics, proceedings, icse.  213-216. 

rosminazuin ab. rahim, badariah bais, burhanuddin yeop majlis.  (2014).  simple microcantilever release process of silicon piezoresistive microcantilever sensor using wet etching.  - applied mechanics and materials.  894-898. 

rosminazuin ab rahim, badariah bais, burhanuddin yeop majlis, and sheik fareed.  (2013).  design optimization of mems dual-leg shaped piezoresistive microcantilever.  - ieee regional symposium on micro and nanoelectronics (rsm2013).  . 

abdullah m., bais b., hasbi a. m., abd m. r., yatim b., mohd a. m. a, bahari s.a., mat d. n., mokhtar m. h., mohd z. a. f., asillam m.f..  (2013).  development of ukm-sid teaching module for space science education.  - procedia social and behavioral sciences - 6th international forum on engineering education (ifee 2012).  80-85. 

arsad. n., mastang, bais. b., husain. h., kamal. n., saibani. n., hanafi. m., riza atiq abdullah o. k..  (2013).  impact of fiber to the home (ftth) animation on student learning and motivation in electrical engineering.  - 2013 12th international conference on information technology based higher education and training (ithet).  . 

jumril yunas, burhanuddin yeop majlis, azrul azlan hamzah and badariah bais.  (2013).  si monolithic planar coreless inductors for high frequency signal transmission.  - 2013 ieee international rf and microwave conference (rfm2013).  . 

hafizah husain, badariah bais, aini hussain, salina abdul samad.  (2012).  how to construct open ended questions.  - procedia social and behavioral sciences - ukm teaching and learning congress 2011.  . 

mohd hazrul zakaria, badariah bais rosminazuin ab. rahim and burhanuddin yeop majlis.  (2012).  geometrical characterization of single layer silicon based piezoresistive microcantilever using ansys.  - proc. ieee international conference on semiconductor electronics (icse2012).  . 

badariah bais, mardina abdullah, azah mohamed.  (2012).  initial development of project monitoring system for masters coursework.  - procedia - social and behavioral sciences.  . 

mohammadmahdi vakilian, maryam mousavi, badariah bais and burhanuddin yeop majlis.  (2012).  optimization of cantilever-based mems switch.  - proc. ieee international conference on semiconductor electronics (icse2012).  . 

mardhiah mohd nor, badariah bais, norazreen abd aziz, rosminazuin ab. rahim and burhanuddin yeop majlis.  (2012).  induced mass change technique for glucose detection in microcantilever-based sensors.  - proc. ieee international conference on semiconductor electronics (icse2012).  . 

rosminazuin ab rahim, badariah bais, burhanuddin yeop majlis and gandi sugandi.  (2012).  an alternative polymeric protection mask for bulk koh etching of silicon.  - symposium on design, integration and packaging of mems/moems (dtip2012).  . 

rosminazuin ab rahim, badariah bais and burhanuddin yeop majlis.  (2011).  double-step plasma etching for sio2 microcantilever release.  - international conference on materials for advanced technologies, icmat2011 - symposium g: nems/mems and microtas; suntec (advanced materials research).  . 

wedianti shualdi, badariah bais, ibrahim ahmad, ghazali omar, aishah isnin.  (2011).  nanoindentation characterization of sn-ag-sb/cu substrate imc layer subject to thermal aging.  - 2011 ieee regional symposium on micro and nano electronics, rsm 2011; kota kinabalu, sabah.  . 

badariah bais, norazreen abd. aziz and norbahiah misran.  (2011).  curriculum restructuring of bachelor of engineering program.  - kongres pengajaran dan pembelajaran ukm, 2010; tanjung keling, melaka.  . 

badariah bais, liang wen loh, rosminazuin ab rahim, burhanuddin yeop majlis.  (2011).  optimization of on-chip interface circuit for mems sensor based on micro-cantilever.  - international conference on materials for advanced technologies, icmat2011 - symposium g: nems/mems and microtas; suntec(advanced materials research).  . 

badariah bais, shamsul rahimi a. subki, chi chin yap, chang fu dee and burhanuddin yeop majlis,.  (2011).  process development on synthesizing zinc oxide nanorods and fabrication of idt finger electrodes for surface acoustic wave devices.  - 2011 ieee regional symposium on micro and nano electronics, rsm 2011; kota kinabalu, sabah.  . 

norazreen abd aziz, norhana arsad, badariah bais, afida ayob dan hafizah husain.  (2011).  teaching methodology evaluation using rasch analysis.  - 10th wseas international conference on system science and simulation in engineering (icossse `11).  . 

n. a. muhammad, b. bais, i. ahmad and a. isnin.  (2011).  effect of reflow soldering process on metallurgical bonding between sn3.5ag solder and enig substrates.  - materials research innovations.  . 

afida ayob, badariah bais, norazreen abd aziz, norhana arsad and hafizah husain.  (2011).  use of rasch analysis in engineering students psychometric evaluation.  - 2011 3rd international congress on engineering education (iceed), 7-8 december 2011, malaysia.  . 

p. s. menon, k. kumarajah, b. bais, h. abdullah, majlis, b. y. and apte, p. r..  (2010).  peak power and wavelength optimization of a double-fused lw-vcsel.  - proceedings of the 2010 ieee international conference on semiconductor electronics, icse2010 (melaka).  . 

masoomeh tehranirokh, burhanuddin yeop majlis and badariah bais.  (2008).  design of a micromechanical system utilizing hydrogel force for controlling a microvalve.  - proceeding international conference on semiconductor electronics (icse2008), johor bahru, malaysia.  . 

azrif manut, badariah bais and burhanuddin yeop majlis.  (2004).  mechanical behaviour of a 10g mems non-crossing differential capacitive accelerometer.  - proc. 2004 ieee international conference on semiconductor electronics (icse2004), kuala lumpur.  . 

badariah bais & burhanuddin yeop majlis.  (2004).  suspension design analysis on the performance of mems area-changed lateral capacitive accelerometer.  - proc. 2004 ieee international conference on semiconductor electronics (icse2004), kuala lumpur.  .